Home Improvement / September 19, 2018 / Adaline Faure.
So a ceramic tile layout program for your walls or floor is definitely on the cards whether you are setting up your new home or revamping.
Before you start with a ceramic tile layout program, get the basics right and choose your tiles carefully. The success of your entire ceramic tile layout program depends upon whether you choose the moisture and stain-resistant, hard glazed tiles or the relatively more scratchproof but softer unglazed tiles that are prone to stain.
Installing the tiles right is the crux of your ceramic tile layout program. This installation procedure may sound daunting, but it is all about following a few necessary steps.
The tips to a fruitful ceramic tile layout program highlight on a sturdy subfloor to act as the backing to the tiles. Ceramic tiles are unyielding and hence may crack while supporting weights if there is no subfloor.
The most crucial stage in a ceramic tile layout program is preparing an existing floor for the new tiles. Thus you need to take off the baseboards for the time being and trim the moldings. All appliances and furniture should also be removed before you get down to work on your ceramic tile layout program. This holds for vinyl flooring too.
However, you need to remember that the installation of these ceramic tile backer boards will raise your floor and you would require making adjustments to the transitions, that is the points where the level meets the walls.
A ceramic tile layout program involves aesthetics also. Thus the how-tos of a ceramic tile layout program insist on drawing out reference lines and then laying out the tiles first without the adhesive to check for any irregular arrangements. Start laying out the pipe from the main door so that an entire row of tiles is visible from the entrance. Also, ensure that the tubes at the corners of the room are of equal width and at least half a tile wide.
Before you start fixing the tiles, apply a fine coat of thinset mortar over the substrate. Lay down the tile and the mortar while the coat is still wet.
While you are working with the thinset mortar and the tiles, make sure to wipe off the thinset from the grout joints so that the grout can penetrate deeper and provide a firm anchorage to the pipes.
To round off your ceramic tile layout program with a flourish, apply grout to the joints liberally. Let it thicken for about 15 minutes, before removing the excess grout with sponge and water. Your ceramic tile layout program is complete.
A ceramic tile layout program is actually about taking care of the little issues so that the ground beneath your feet doesn’t give away.